Selection of IO-Link bus IO precast cables for Solidot Technology

Shidian Technology's IO-Link master module products can achieve an IP67 Protection rating, allowing direct use in environments outside the control cabinet. To avoid compromising the overall IP67 Protection rating, pre-molded connectors are generally used. Pre-molded connectors, also known as pre-cast cables, are an important component of IP67 fieldbus I/O systems. Compared with field-wired connectors, they can significantly reduce installation costs and save installation time. Their material and structural characteristics make them suitable for use in complex industrial environments such as humidity and oil contamination.

① Communication cable: AZG/R-1.0CS D-Code male/RJ45, cable length 1 m, C stands for PVC, S stands for Shield Layer

② Communication Cascading cable: AZG/AZG-1.0CS D-Code male/D-Code male, C stands for PVC, S stands for Shield Layer

③ Power Supply cable: BZM/S-1.0C L-Code female/open-ended wire, cable length 1 m, PVC, unshielded

④ Power Supply Cascading cable: BZG/BZM-1.0C L-Code male/L-Code female, cable length 1 m, PVC, unshielded

⑤ I/O cable: CZG/CZM-1.0C A-Code male/A-Code female, cable length 1 m, PVC, unshielded

Note: Cable length can be customized. 1.0 is used here as an example; options are generally 0.5/1/2/3/5/10/20.

C stands for PVC, which meets most requirements with excellent cost-effectiveness. For higher requirements, PUR material can be selected by changing C to R in the model, e.g. AZG/R-1.0RS. All products in this series feature a Shield Layer.

① IO-Link communication cable: CZG/CZM-1.0C A-Code male/A-Code female, cable length 1 m, PVC, unshielded, same as the master's I/O cable

② I/O cable: CZG/S-1.0C A-Code male/open-ended wire, cable length 1 m, PVC, unshielded

Note: Cable length can be customized. 1.0 is used here as an example; options are generally 0.5/1/2/3/5/10/20.

C stands for PVC, which meets most requirements with excellent cost-effectiveness. For higher requirements, PUR material can be selected by changing C to R in the model, e.g. CZG/CZM-1.0RS. All products in this series feature a Shield Layer.

An ordinary sensor is generally two-wire or three-wire, and one channel of the module supports two digital signals. Therefore, a splitter may be used here, such as the M12/M8 Y-type splitter DYG/EYM, 80120000320.